STEINEL HF 3600 Manual descarregar pdf (Página 8)

14 15

Installation of corner wall mount

Reach adjustment

(Sensitivity) 

The desired reach of the

sensor can be continuously

adjusted from approx.

1 m to the maximum reach

of approx. 8 m. Adjusting

screw left stop position

means: minimum reach (ap-

prox. 1 m / factory setting).

Adjusting screw right stop

position means: maximum

reach (approx. 8 m).

The sensor can be installed

conveniently on inside and

outside corners using the

corner wall mounts pro-

vided. Use the corner wall

mount as a drilling template

when drilling the holes. In

this manner, the drilling hole

is set at the correct angle

and the corner wall mount

can be easily installed.

Functions

Time setting

(Switch-off delay) 

The desired illumination

time of the connected

light can be continuously

adjusted from approx.

5 sec. to max. 30 min.

Adjusting screw left stop

position means: shortest

time approx. 5 sec. (factory

setting). Adjusting screw

right stop position means:

l

ongest time approx. 30 min.

The timer is started again

by any motion detected

before this time elapses.

During adjustment of the

detection zone and for

the performance test, it is

recommended to set the

shortest time.

Note: After every off

switching, further motion

detection is interrupted for

approx. 2 seconds. Only

after this time elapses can

the SensorSwitch switch

on light again in response

to motion.

Twilight setting

(Response threshold) 

The desired response

threshold of the sensor can

be continuously adjusted

from approx. 2 lux to

2000 lux.

Adjusting screw right stop

position means: daylight

operation approx. 2000 lux

(factory setting). Adjusting

screw left stop position

means: nighttime operation

approx. 2 lux.

When adjusting the detec-

tion zone and for the per-

formance test in daylight,

the adjusting screw must

be set to the right stop

position.

Additional functions by a mains switch

If a mains switch is installed

in the supply lead, the

following functions are pos-

sible in addition to merely

switching ON and OFF of

the connected light.

Important: The switch

should be operated in rapid

succession (in the range

0.5 - 1 sec.).

1) Switch on the light:

Switch 2 x OFF and ON.

The light is set to perman-

ent light for 4 hours (red

LED illuminates behind

the lens). It subsequently

returns automatically to

sensor mode (red LED off).

2) Switch off light:

Switch 1 x OFF and ON.

The light goes out, or after

15 sec. transfers to sensor

mode.

4 hours

2 x OFF/ON

1) Switch on the light:

Switch 1 x OFF/ON.

The light remains on for

the set time.

2) Switch off the light:

Switch 1 x OFF and ON.

The connected light goes

out, or after 15 sec. trans-

fers to sensor mode.

5 sec. - 30 min.

1 x OFF/ON

2 - 2000 lux

5 sec. - 30 min.

1 - 8 m

Sensor operation

Permanent light

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 57 58

Comentários a estes Manuais

Sem comentários